Regulatory information, Power supply, 5 regulatory information – Brocade Mobility RFS4000 Controller Installation Guide (Supporting software release 4.3.0.0 and later) User Manual
Page 35
Brocade Mobility RFS4000 Controller Installation Guide
25
53-1001933-02
Chapter
5
Regulatory Information
In this chapter
•
•
Laser devices - Gigabit Ethernet SFP option
•
Radio frequency interference requirements - FCC
•
Radio frequency interference requirements - Canada
•
CE Marking and European Economic Area (EEA)
•
Waste Electrical and Electronic Equipment (WEEE)
This regulatory section applies to the Brocade Mobility RFS4000 Controller.
All Brocade devices are designed to be compliant with rules and regulations in
locations they are sold and will be labeled as required.
Any changes or modifications to Brocade equipment, not expressly approved by
Brocade, could void the user’s authority to operate the equipment.
CAUTION
This product is designed and approved for in-building installation only
and is not intended to be connected to exposed (outside plant)
networks.
Power supply
Use only a Brocade approved power supply output rated at 48Vdc and minimum
2.5A. The power supply shall be Listed to UL/CSA 60950-1; and certified to
IEC60950-1 and EN60950-1 with SELV outputs. Use of alternative power supply
will invalidate any approval given to this device and may be dangerous.
MobilityRFS4000ControllerInstallGuide.book Page 25 Friday, June 10, 2011 1:32 PM