Brocade Mobility RFS4000 Controller Installation Guide (Supporting software release 4.3.0.0 and later) - Manual (Page 13)

Warnings
1
Brocade Mobility RFS4000 Controller Installation Guide 3
53-1001933-02
Warnings
• Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the system to its power source.
• Remove jewelry and watches before installing this equipment.
• Install the equipment in a rack or on a desktop with adequate dimensions and
weight allowances.
• Verify the unit is grounded before connecting it to the power source.
• Verify any device connected to this unit is properly wired and grounded.
• Connect all power cords to a properly wired and grounded electrical circuit.
• Verify the electrical circuits have appropriate overload protection.
• Brocade strongly recommends the use of an Uninterruptible Power Supply
(UPS) that supports the Brocade Mobility RFS4000 Controller power rating. Not
using a UPS can result in data loss or equipment damage due to a power surge
or power failure.
• Verify that the power connector and socket are accessible at all times during
the operation of the equipment.
• Do not work with power circuits in dimly lit spaces.
• Do not install this equipment or work with its power circuits during
thunderstorms or other weather conditions that could cause a power surge.
• Verify there is adequate ventilation around the device, and ambient
temperatures meet equipment operation specifications.
• This product is designed for in building installation only and is not intended to
be connected to exposed (outside plant) networks.
Site preparation
• Consult your site survey and network analysis reports to determine specific
equipment placement, port capacity, power drops, and so on.
• Assign installation responsibility to the appropriate personnel.
• Identify where all installed components are located.
• Verify appropriate rack mounting requirements, as required.
• Provide a sufficient number of power drops for your equipment.
MobilityRFS4000ControllerInstallGuide.book Page 3 Friday, June 10, 2011 1:32 PM