Brocade Mobility RFS4000 Controller Installation Guide (Supporting software release 4.3.0.0 and later) - Manual (Page 30)

Brocade Mobility RFS4000 Controller console port setup
4
20 Brocade Mobility RFS4000 Controller Installation Guide
53-1001933-02
3. Attach the mounting tray to the rack using screws appropriate for your rack’s
mounting holes.
Brocade Mobility RFS4000 Controller console port
setup
To add the Brocade Mobility RFS4000 Controller to the network and prepare it for
initial configuration:
1. Using the supplied console cable (pictured below), connect the Brocade
Mobility RFS4000 Controller serial port to an RS-232 (DB-9) serial port on a
separate computer (the “configuration computer”).
The pinout for the RJ-45 to DB9 cable is shown in the following table.
RJ-45 1 2 3 4,5 6 7 8
DB9 8 6 2 5 3 4 7
MobilityRFS4000ControllerInstallGuide.book Page 20 Friday, June 10, 2011 1:32 PM