Brocade Mobility RFS7000-GR Controller Installation Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 35
Changing default wireless controller parameters
5
Brocade Mobility RFS7000-GR Controller Installation Guide
27
53-1001946-01
NOTE
The password a%defMyj is only an example. Enter a unique password in place of
this example.
4. Country code must be set to the appropriate country in order to have proper
channel of operations. Access Points are adopted after the country code is set.
a. Enter “wireless configuration mode”
RFS7000(config)#wireless
b. Execute the following in wireless configuration mode.
RFS7000(config-wireless)#country-code us
CAUTION
Select only the country in which you are using the device. Any other
selection may make the operation of this device illegal.
5. The default SSID for all WLANs (wireless LANs) in the system is “101”. This
SSID should be changed to ensure secure operation.
a. Go to “wireless configuration mode” and execute the following:
RFS7000(config-wireless)#wlan 1 ssid myOwnSsid
NOTE
The SSID of myOwnSsid is only an example. Enter a unique SSID in place of
this example.
6. The default encryption for the WLAN must be changed before enabling the
WLAN.
a. Select the Encryption type. The default encryption is AES/CCMP.
RFS7000(config-wireless)#wlan 1 encryption-type ccmp
b. By default pre-shared key is used for AES/CCMP encryption with a default
key used for all WLANs. This key must be changed before enabling the
WLAN.
RFS7000(config-wireless)#wlan 1 dot11i key 0
acdefab12345678abcdefab12345678abcdefab12345678abcdefab123456
78