Brocade Mobility RFS7000-GR Controller Installation Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 15)

Brocade Mobility RFS7000-GR Controller Installation Guide 7
53-1001946-01
Chapter
3
LED Codes
In this chapter
• System status LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
• RJ-45 gigabit Ethernet LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . 11
• SFP gigabit Ethernet LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
• Out of band management port LEDs. . . . . . . . . . . . . . . . . . . . 13
• Out of band management port status LED . . . . . . . . . . . . . . . 13
The Brocade Mobility RFS7000-GR Controller has four vertically-stacked LEDs on its
front panel. Each of the controller’s Gigabit Ethernet ports have two status LEDs.
These LEDs display two colors (green & amber), and three lit states (solid, blinking,
and off). The following tables decode the combinations of LED colors and states for
the System Status LEDs and the Gigabit Ethernet LEDs.