Brocade Mobility RFS7000-GR Controller Installation Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 34)

Changing default wireless controller parameters
5
26 Brocade Mobility RFS7000-GR Controller Installation Guide
53-1001946-01
Password is same as default password, please change the password
Enter old password:
Enter new password:
Re Enter new password:
Password for user 'admin' changed successfully
RFS7000>
5. Once Username and Password credentials are validated, the below prompt will
returned. Enter “Enable” to get into execution mode.
RFS7000>enable
RFS7000#
6. To get into configuration mode, enter “configure terminal” at “exec-mode”
prompt above.
RFS7000# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
RFS7000(config)#
Changing default wireless controller parameters
The various default parameters which must be changed to operate the wireless
controller in a secured operational mode are listed below:
1. Change the SNMP users (snmpoperator, snmpmanager and snmptrap) default
passwords to new values.
Go to the global configuration context and change the default passwords of
SNMP for all the 3 SNMP users.
RFS7000(config)#snmp-server user snmpmanager v3 encrypted des
auth md5 RFS7000(config)#snmp-server user snmpoperator
v3 encrypted des auth md5
RFS7000(config)#snmp-server user snmptrap v3 encrypted des auth
md5
2. By default SNMP manager is disabled and need to start SNMP manager for GUI
access. Go to the global configuration context and start SNMP manager.
RFS7000(config)#snmp-server manager v3
3. Change the default Admin password ( Superuser) .
RFS7000(config)#username admin password 0 a%defMyj