Brocade Mobility RFS7000-GR Controller Installation Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 30)

Supplying power to the Brocade Mobility RFS7000-GR Controller
4
22 Brocade Mobility RFS7000-GR Controller Installation Guide
53-1001946-01
Supplying power to the Brocade Mobility RFS7000-GR
Controller
1. Plug an approved AC power cord into the power connector at the back of the
Brocade Mobility RFS7000-GR Controller.
2. Plug the cord into a standard AC outlet with a voltage range of 100 to 240 VAC.
CAUTION
An improper shutdown can render the Brocade Mobility RFS7000-GR
Controller inoperable such that it could require service by Brocade
Support. Do not remove AC power without first following the shutdown
procedure. An abrupt loss of power can corrupt the information stored
on the device.
Verifying the installation
View the LEDs on the front panel of the Brocade Mobility RFS7000-GR Controller to
ensure the device is functioning properly. The normal LED pattern follows this path:
V\PB
5DFNPRXQW
EUDFNHW
$&LQOHW