Brocade Mobility RFS7000-GR Controller Installation Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 33)

Brocade Mobility RFS7000-GR Controller Installation Guide 25
53-1001946-01
Chapter
5
Secure Installation Procedure
In this chapter
• Command line interface login procedure for the wireless controller 25
• Changing default wireless controller parameters. . . . . . . . . . 26
This installation procedure explains how to login to the Command Line Interface for
initial configuration.
Through this process the wireless controller is configured with a set of default
values for specific features. These default values should be changed in order to
maintain the security of the wireless users and access to the controller.
Command line interface login procedure for the
wireless controller
1. Enter “cli” at login prompt
RFS7000 login: cli
This device is running on FIPS mode.
Attention:
This is a protected and private wireless system. No un-authorized
access allowed. You must have proper rights to access and manage
this system from the authorized personnel.
Do you want to proceed? (y/n):y
2. Enter “admin” at username prompt
Username: admin
3. Enter “0umP.s45fIOD6” at Password prompt below. (“0umP.s45fIOD6 is the
default password for admin user).
Password:
4. Once Username and Password credentials are validated, the controller will
prompt to change the default password to a new value. Please change the
default password of the admin user.