Brocade Mobility RFS7000-GR Controller Installation Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 16)

System status LEDs
3
8 Brocade Mobility RFS7000-GR Controller Installation Guide
53-1001946-01
System status LEDs
Start up / POST (primary system or redundant system)
NOTE
During controller start up, the Temperature status LED will be lit Solid Amber. This is
normal behavior and does not indicate an error. At the completion of start up the
Temperature Status LED will switch to Solid Green.
Controller status (primary system)
6\VWHP6WDWXV
)DQVWDWXV
7HPSHUDWXUHVWDWXV
6\VWHP6WDWXV
System Status 1 LED System Status 2 LED Event
Off Off Power off
Green Blinking Green Blinking Power On Self Test (POST) running
Green Solid Green Blinking POST succeeded (Operating System Loading)
Green Solid Off POST succeeded (Normal Operation)
Amber Blinking Off POST Failure
Alternating Green Blinking
& Amber Blinking Alternating Green Blinking
& Amber Blinking Boot Up Error: Device has an invalid checksum
System Status 1 LED System Status 2 LED Event
Off Off Power off
Green Solid Off No Redundancy Feature Enabled