Brocade Mobility RFS7000-GR Controller Installation Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 29)

Brocade Mobility RFS7000-GR Controller console port setup
4
Brocade Mobility RFS7000-GR Controller Installation Guide 21
53-1001946-01
1. Using the supplied console cable (pictured below), connect the Brocade
Mobility RFS7000-GR Controller serial port to an RS-232 (DB-9) serial port on a
separate computer (the “configuration computer”).
2. On the configuration computer, configure a terminal emulation application
(such as HyperTerminal) as follows:
Terminal Type VT-100
Port COM port
Terminal Settings 19200bps transfer rate
8 data bits
no parity
1 stop bit
no flow control
no hardware compression