Brocade 7800 Extension Switch Hardware Reference Manual - Manual (Page 28)

tsTimeZone command parameter selection TABLE 3
Local Time tsTimeZone parameter (difference from UTC)
Atlantic Standard -4,0
Atlantic Daylight -3,0
Eastern Standard -5,0
Eastern Daylight -4,0
Central Standard -6,0
Central Daylight -5,0
Mountain Standard -7,0
Mountain Daylight -6,0
Pacific Standard -8,0
Pacific Daylight -7,0
Alaskan Standard -9,0
Alaskan Daylight -8,0
Hawaiian Standard -10,0
FCIP and Fibre Channel routing services configuration
The ports on the Brocade 7800 are initially set to persistently disabled.
If you want to enable the FC ports as a standard E_Port or F_port use the portcfgpersistentenable
command to enable the ports.
If you are using the FC ports as EX_Ports you must configure the Fibre Channel Routing Services
feature prior to enabling the ports.
The GbE ports can only be used once you have configured FCIP and enabled the VE_Ports.
See the Fabric OS Administrator's Guide for detailed instructions on configuring the Fibre Channel
Router ports and GbE ports on the Brocade 7800.
Installing SFPs and cabling the Brocade 7800
Perform the following steps to install SFPs and cable the switch.
1. Install the SFP transceivers in the Fibre Channel ports, as required. The ports selected for use in
trunking groups must meet specific requirements. For a list of these requirements, see the Fabric
OS Administrator's Guide.
a)
Remove the plugs from the ports to be used.
b) Position a transceiver so that it is oriented correctly and insert it into a port until it is firmly
seated and the latching mechanism clicks.
FCIP and Fibre Channel routing services configuration
28 Brocade 7800 Extension Switch Hardware Reference Manual
53-1001350-05