Brocade Encryption Switch Hardware Reference Manual (Supporting Fabric OS v6.1.1_enc) - Manual (Page 40)

26 Brocade Encryption Switch Hardware Reference Manual
53-1001117-02
3
Port status No light Indicates one of the following:
•
No signal or light carrier (media
or cable) detected.
•
The switch may be initializing.
•
Connected device is configured
in an offline state.
Try the following:
•
Verify the power LED is on, and
check the SFP and cable.
•
Verify the switch is initializing.
•
Verify the status of the
connected device.
Steady green Port is online (connected to external
device) but has no traffic. No action required.
Slow-flashing
green (on 1
second; then off 1
second) Port is online but segmented
because of a loopback cable or
incompatible switch connection. Verify that the correct device is
attached to the switch.
Fast-flashing green
(on 1/4 second;
then off 1/4
second) Port is online and an internal
loopback diagnostic test is running. No action required.
Flickering green Port is online and frames are flowing
through the port. No action required.
Steady amber Port is receiving light or signal
carrier, but it is not online yet. No action required.
Slow-flashing
amber (on 2
seconds; then off
2 seconds) Port is disabled because of
diagnostics or the portDisable
command. Verify the diagnostic tests are not
running. Re-enable the port using the
portEnable command.
Fast-flashing
amber (on 1/2
second; then off
1/2 second) SFP or port is faulty. Replace the SFP.
Reset the port.
TABLE 2 Switch and FRU LEDs (Continued)
LED Name LED Color Status of Hardware Recommended Action