Brocade Encryption Switch Hardware Reference Manual (Supporting Fabric OS v6.1.1_enc) - Manual (Page 29)

Brocade Encryption Switch Hardware Reference Manual 15
53-1001117-02
2
Connecting a serial cable between switch and host
Follow these steps to connect a serial cable.
1. Remove the plug from the serial port and connect the serial cable provided with the switch.
2. Connect the cable to an RS-232 serial port on the workstation.
If the serial port on the workstation is RJ-45 instead of RS-232, remove the adapter on the end
of the serial cable and insert the exposed RJ-45 connector into the RJ-45 serial port on
the workstation.
3. Disable any serial communication programs running on the workstation.
4. Open a terminal emulator application (such as HyperTerminal on a PC, or term, tip, or kermit in
a UNIX environment), and configure the application as follows:
• In a Windows environment:
• In a UNIX environment, enter the following string at the prompt:
tip /dev/ttyb -9600
If ttyb is already in use, use ttya instead and enter the following string at the prompt:
tip /dev/ttya -9600
Logging in to the serial console port
To log in to the switch through the serial connection, follow these steps.
1. Verify that the switch has completed POST. When POST is complete, the port status and switch
power and status LEDs return to a standard healthy state; for information about LED signals,
see
“Interpreting LEDs” .
2. When the terminal emulator application stops reporting information, press Enter to display the
login prompt.
3. Log in to the Switch as admin, using the default password: password. You are prompted to
change the default passwords at initial login.
Parameter Value
Bits per second 9600
Databits 8
Parity None
Stop bits 1
Flow control None