Anthro Elevate Original Adjusta Assembly Instructions - Manual (Page 7)

6 Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
Elevate Adjusta Assembly Instructions 7
STEP 11
Install Cross Bar & End Caps
¡ Using the keypad, move the table all the way up. Check the legs for
excess lubricant and wipe down if needed.
¡ Align the cross bar so that the tapered ends of the cross bar brackets
line up with the leg brackets. Using the mallet, drive the cross bar
completely into place (a few whacks on the left, a few on the right,
then left, then right...).
¡ Plug the power cord into the control box and an outlet. Insert a cable clip
into the base tube closest to the Control Box and route the power cord through it.
STEP 12
Home the Legs
¡ Press the Down button on the keypad three times, and hold down on the third time for about 5-10 seconds until you hear
a slight click and the table bumps up-down-up.
¡ If the legs fail to function properly, unplug the power, wait 10 seconds, plug the power back in and repeat the above step.
¡ Legs must also be homed any time power is disconnected from the legs.
STEP 13
Add Accessories and Install Your Equipment
¡ Now add your Anthro accessories and install your equipment.
¡ A word of caution: the height range of Elevate may be longer than the cords on your equipment. Equipment that is
mounted in a SideRack w/Caster or Equipment Shelf, for example, will not move up and down with the table. Raise and
lower the table to its highest and lowest positions when all equipment is installed to make sure that the cords are long
enough. Double-check that all the table's cords and cables reach comfortably through the table's entire range of motion.
STEP 10
Add Casters and Turn Table Right Side Up
¡ Thread casters into the inserts in each leg. This is a lot easier if you lock the casters first.
¡ With the help of another person, carefully rotate the table onto its casters.
STEP 9
Attach Cable Trough and Tighten All Screws
¡ Align the cable trough with the flanges on each leg
gusset and the pre-drilled holes on the monitor shelf.
Before installing the trough, make sure that cables are
routed through the ends of the trough, not into the
side of the trough. Secure the trough to the gussets
with four 3/8" Button-head Screws. Secure the trough
to the monitor shelf using eight 1" Button-head
Screws.
¡ Tighten all the Wood Screws on the Cable Trough, the
Leg Gussets, and the Mechanism.
3/8" Screw
325-5149-00
Cable Clip
Hole
Cable Snap-in Clip
175-51188-00
1” Btn-Hd Screw
325-5580-00