Anthro Elevate Original Adjusta Assembly Instructions - Manual (Page 4)

4 Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
Elevate Adjusta Assembly Instructions 5
STEP 5A
Assemble Adjusta Mechanism
¡ Your Adjusta mechanism comes
unassembled and is boxed separately
inside the package. Locate the small bag
of hardware included with the Adjusta
Mechanism. It includes (1) Post, (1) Cotter
Pin, (2) Hex Nuts, (2) Wood Screws, and (2)
Cable Mounts.
¡ Begin to assemble the mechanism by first
locating the Crossbar and Brake/Paddle
assembly and position them as shown at
right. Depress the Paddle once to free the
Brake Shaft.
¡ Place the Brake Shaft between the two
center Crossbar flanges. Insert the Post
through both center Crossbar flanges and
the Brake Shaft.
¡ Install the Cotter Pin through the single
opening of the post to secure it in place.
Center Crossbar Flanges
Brake Shaft
Crossbar
Post
(included with 225-5548-00)
Brake/Paddle Assembly
STEP 3
Attach Leg Assemblies to Shelf
¡ Place the work surface upside down on a cushioned non-marring
surface that's elevated about 12" above the floor. Stacking the table's
shipping box and the adjusta mechanism box works well (just remove
the mechanism first). Invert one leg assembly over the work surface
so the side flange is against the side of the work surface, the heads of
the cap screws at the top of the leg assembly rest in the recessed holes
in the work surface, and the holes in the gusset line up with the pre-
drilled holes in the work surface.
¡ Loosely attach with four 1" Button-head Screws. If you aren't installing
an Elevate SideRack 760zz, install additional screws through the four
open holes on the gusset. Don’t tighten all the way.
¡ Repeat for the other leg assembly.
If you have purchased an Elevate SideRack 760zz, install it now.
STEP 4
Attach Cross Tubes to Base Tubes
¡ Position the two Cross Tubes as shown. Insert one Cap
Screw with a Basetube Washer through a side hole,
carefully threading the Screw into the Cross Tube, but
do not tighten all the way. Repeat for the remaining
three side holes.
¡ Once all cross tubes are installed, tighten all the
basetube screws. Leave the Wood Screws loose
until after Step 9, installation of the Cable Trough.
Cotter Pin
(included with 225-5548-00)
4" Cap Screw
325-5166-00
Basetube Washer
225-2050-00 (Black)
225-3522-00 (Silver)
Cross Tubes
Cotter Pin
Post
1” Btn-Hd Screw
325-5580-00
Brake Cable