Anthro Elevate II Single Surface Assembly Instructions - Manual (Page 6)

6 Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
STEP 5 - INSTALL CABLE TRAY
ƒ Align the Cable Tray with the back of the table so the holes on the threaded posts on the cross pan line up with the holes
on the cable tray. Attach the tray to the pan with three Nylock Nuts using your own 3/8" socket or the 3-way wrench
provided. (The plastic end of the nut faces up.)
ƒ Connect a 1-meter Control Box Cable to each leg cable, then plug each into a port on the Control Box through the
opening in the support pan. Feed extra cable length through an opening in the support pan so it's organized in the Cable
Tray.
ƒ Route the Keypad's cable back to the Cross Pan and plug it into the Control Box.
Feed extra cable length through an opening in the support pan so it's organized
in the Cable Tray.
ƒ Plug the Power Cord into the Control Box.
ƒ Use the provided cable clips to route and organize cords. Install one cable clip
next to the Leg Gusset for the Keypad Cord. Install the other clip next to the
Cross Pan for the Control Box Cables.
Nylock Nuts
325-5186-00
1/2”Button-hd Screw
325-5193-00
CONGRATULATIONS! YOUR ELEVATE II ASSEMBLY IS COMPLETE!
48w Shallow Table 48w Deep Table
Shown without Control Box for easier view.
Side View
STEP 4B - INSTALL CONTROL BOX AND KEYPAD - SHALLOW TABLES
ƒ Align the keypad and its slider housing with the four pre-drilled holes at the
front of the keyboard surface so the buttons are face-down at the front edge
of the keyboard surface and the flat side of the housing is against the shelf.
The keypad can also be installed directly to the worksurface without the slider
housing, either so it extendds in front of the table or so it's set back a bit.
ƒ Using four Phillips Head Screws (325-5370-00), attach the keypad and its
housing (if desired) to the front of the worksurface. Install these screws by
hand. Too much torque can damage the plastic.
ƒ Align the Control Box with the Cable Tray so the ports face up and the holes
on the Control Box line up with the holes on the Cable Tray. The Control Box
installs at the center of the tray on the 48w table. The 60w table comes with
three installation points (left, center, and right) to allow space for a power bar
or surge protector in the tray. Attach the box to the tray with four 1/2" Button-
head Screws and four Nylock Nuts using your own 3/8" socket (or the 3-way
wrench provided) and the smallest hex key (1/8") in your kit.
Nylock Nuts
325-5186-00
Keypad and Housing
Attaching the Control Box to the Cable Tray
of a shallow 48" wide table.
1/2”Button-hd Screw
325-5193-00
3/4” Phillips Screw
325-5370-00