Anthro Tablet Charging Cabinets Owners Manual - Manual (Page 6)

6 Questions? Call us at 800.325.3841 or visit anthro.com.
STEP 6
Install the Bay Labels and Route Cables
• Your cabinet comes with labels for numbering the bays in your cabinet. Line up each label with the front face of the bay shelf, peel of the
backer, and affix the label.
• Starting at the far left-hand side of each shelf, route one cord through the channel at the top of the divider. The
right-hand divider on each shelf will not have a cord. Make sure the cord end that goes into the device
is at the front of the cart and the power end goes through the back panel and into the IT area. Leave
enough slack in front so users have enough cord to easily plug into the device without straining the cord.
To quickly measure an adequate length, use the height of the divider as a measuring stick.
• In the IT area, poke cable clips into the holes in the pegboard divider and route cords. Plug in each power
adapter, then connect each cord to an adapter. Turn the power switch to the OFF position before plugging
the cart or cabinet into the wall.
CONGRATULATIONS! YOUR CABINET ASSEMBLY IS COMPLETE!
STEP 5
Install Feet
• Stick a 3/4" wood screw through each rubber bumper (581-5063-00).
• Locate the four pre-drilled holes on the bottom of the cabinet, one in each corner. Using the Anthro driver, attach each foot to the
cabinet.
HOW TO REMOVE THE UPPER CABINET SHELF
To store taller devices in a Tablet Charging Cabinet, remove the
upper shelf following these steps:
• Open the front door of the cabinet all the way.
• Using a 7/16" socket, loosen but do not remove the four Keps Nuts located under the upper shelf. [Image E]
• Carefully lift the shelf straight up until the shelf clears the nuts, then tilt the shelf and pull it out. [Images F and G]
• Using the 7/16" socket, tighten the nuts.
E F G