Anthro Tablet Charging Cabinets Owners Manual - Manual (Page 4)

4 Questions? Call us at 800.325.3841 or visit anthro.com.
STEP 1
Select the Mounting Location and Method
ƒ When choosing the right place to install your cabinet, be sure to check the location of your power source. The power
cord that comes with your cabinet is 10 ft long.
ƒ Your cabinet can be wall-mounted to wood wall studs or drywall, or bolt it to a countertop. If you’re installing to wood
wall studs, go to Step 2. If you’re installing into drywall, go to Step 3. If you're bolting to a countertop, go to
Step 4. The cabinet also comes with cushioned feet; use them if you're placing your cabinet on a flat surface. See Step 5
for installation instructions.
STEP 2
Wall-mount to Wood Wall Studs
This is a two-person step.
ƒ Determine the installation point for your cabinet.
Using a stud finder, locate the studs. While one person
holds the cabinet frame up to the wall at the desired
height, the other marks the height of the top of the
cabinet. Measure down 1-1/2" along the studs to
determine the position of the screws and mark where
the screws will go. Use a level to make sure the marks
are level.
ƒ Using a 1/8" drill bit, drill one hole in a stud about
1-1/2" deep. How do you make sure that hole is
1-1/2" deep? Measure that length on your drill bit
and mark it with a piece of masking tape. Stop drilling
when you reach the masking tape. Repeat for the
second screw.
ƒ Using a Phillips driver (or a power driver with a
Phillips bit), attach the first 1-5/8" long screw at that
mounting point, but don’t tighten all the way to the
wall. Stop tightening when the screw head is about
1/4" away from wall.
ƒ Lift the cabinet onto the wall. Mark the screw position
of the lower screws. Remove the cabinet, drill the
lower holes, and install the lower screws. Lift the
cabinet into place and tighten all four screws.
Go to Step 6.
1-5/8" Screw
325-5086-00
Drill
Wall Stud Profile
1½"
Tape ¼ "
Screw