Ab c d, Step 3, Step 4 – Anthro Tablet Charging Cabinets Owners Manual User Manual
Page 5

Owner's Manual for Anthro Tablet Charging Cabinets
5
STEP 3
Wall-mount to Drywall
Determine the installation point for your cabinet.
While one person holds the cabinet frame up to the
wall at the desired height, the other marks the height
of the top of the cabinet. Measure down 1-1/2" to
determine the position of the screws and mark where
the screws will go. Use a level to make sure the
marks are level.
Drill 1/2" diameter hole at the mounting point.
Insert a TOGGLER into one hole, metal end first.
Pull the plastic ring end so the metal channel rests
flush behind the wall. With your other hand, slide the
plastic cap along the straps until the flange of the cap
is flush with the wall.
Place your thumb between the plastic straps. Push
side to side, snapping off the straps at the wall.
Insert a 1-5/8" long screw into the TOGGLER, but don't
tighten all the way. Leave the bolt head about 1/4"
from the plastic cap.
Repeat for the second TOGGLER.
Lift the cabinet onto the wall. Mark the screw position
of the lower screws. Remove the cabinet and install
the lower TOGGLERs. Lift the cabinet into place and
tighten all four screws.
Go to Step 6.
A
B
C
D
STEP 4
Bolt-through Installation to Countertop
Pre-drill a 1/4" dia hole in your countertop or shelf.
Using a box knife, slice through the membrane covering the pre-drilled
holes on the bottom of the cabinet.
Slide the 3.5" bolt through the washer, through the bottom of the cabinet,
through the countertop, and capture with the 325-5259-00 nut.
Go to Step 6.
5/8" Washer
325-5379-00
3.5” Bolt
325-5657-00