Anthro Tablet Charging Cabinets Owners Manual - Manual (Page 3)

Owner's Manual for Anthro Tablet Charging Cabinets 3
Loading Devices, Cable Management
Visit anthro.com/tablet to see tips and tricks for wiring up Anthro
Tablet Charging Solutions in our Wire Showdown video!
In the front User area of the cabinet
• Starting at the outside of each shelf, route one charging cord
along the top of each divider. Make sure that the cord end
that goes into the devices is at the front of the bay and that
the power end goes to the
back panel and into the IT
area.
• Leave enough slack in front
(approximately 4.5”; use
the height of the divider
as a measuring stick) so
users can plug in the device
without straining the cord.
[Image A]
• Weave the cord around the
short hook at the front of
the divider, then back and
forth through the three long
channels along the top of
the divider, including the
center channel that’s lower
than the others, and finally
through the short hook
at the back of the divider.
[Image B and C]
• Feed the rest of the cord
into the IT area. [Image D]
A
B
C
D
In the side IT area of the cabinet
• Plug in each power adapter,
then poke cable clips into
the holes in the pegboard
divider – one cable clip per
adapter should do. Coil each
cord and secure it into the
cable clip before plugging it
into the adapter. [Image E]
• A great technique for coiling
cables is to wind them
around two fingers before
securing them in the cable
clips. [Image F] Be sure to
leave enough slack in your
cord so it can plug into the
adapter.
• Plug the cord into the
adapter. [Image G]
• For devices with large power
adapters, first bundle the
cord and adapter together
to save space, then plug
in the adapter. Finally, use
cable clips to secure the
bundle to the pegboard
divider.
• Turn the power switch to
the OFF position before
plugging the cabinet into
the wall. [Image H]
E
F
G
H