Anthro Carl's Table CT12 Owners Manual - Manual (Page 5)

Carl's Table ® CT12 Owner's Manual and Trouble-shooting Guide 5
CT12 OWNERS' MANUAL AND TROUBLE-SHOOTING GUIDE
Relocating Carl's Table
If you'd like to relocate your Carl's Table, please contact us for assistance! Relocating the table without Anthro or our authorized agent
will void the warranty.
Installing Your Equipment
Only your IT personnel can install your hardware onto Carl's Table.
ATTACHING THE KNUCKLES TO THE MONITOR
ƒ Place your monitor face down on a non-marring surface with the top of the monitor
away from you.
ƒ Align the knuckle with the monitor so the holes on the knuckle line up with the holes
on the back of the display and the tilt release lever is on the right.
ƒ Attach the knuckle to the monitor with four M4 x 8mm Phillips screws (325-A129-
18-01-00). If the attachment area on the back of your display is recessed and the
knuckle won’t fit into it, use the spacers (325-5640-00) and the longer M4 x 18mm
(325-A300-05-01-00) screws.
INSTALL THE MONITOR TRACK
ƒ The Monitor Track can be installed either by loosening the knob and sliding the
assembly over the end of the monitor boom or by removing the knob and clamping
the assembly over the center of the monitor boom. When installed, the knob is above
the monitor boom.
ƒ For additional height adjustment, install the track at a different height on the clamp.
Using a 3/8" hex, remove the four screws holding the track to the clamp, reposition,
and reinstall. Account for the height of the installed display.
INSTALL THE KNUCKLE
ƒ Remove and set aside the fastener at the top of the monitor track.
ƒ Slide the Monitor Block into the track with the hooks facing down. Hook it into
the slots at the desired height.
ƒ Slide the Monitor and Knuckle assembly into the track until it rests on the
block. Check the height. If needed, slide the assembly out, reposition the
Monitor Block, and reinstall the Monitor and Knuckle assembly. If you have a
Monitor Vertical Extension, repeat for the second Block and Knuckle assembly.
ƒ Replace the fastener at the top of the monitor track. Repeat for remaining
knuckles.
ƒ Once all knuckles are installed, fine-tune their height and “yaw” (side-to-side
tilt). Two height adjustment screws are located on the back of the knuckle just
above the block, one on the left side and one on the right. Insert the long 3/16”
hex key into the opening and turn clockwise to move that side up, counter-
clockwise to move it down.
Yaw adjustment screws.