Anthro Carl's Table CT12 Owners Manual - Manual (Page 4)

4 Questions? Call us at 800.325.3841 or visit anthro.com/carl. We’re happy to help!
CT12 OWNERS' MANUAL AND TROUBLE-SHOOTING GUIDE
Programmable Presets
Program your preferred height and tilt positions right into the table! Carl's Table CT12 has 99 programmable presets. The preset display
indicates which setting is active.
To preset a table position:
1) Move the table to the desired height and tilt position.
2) Enter the two-digit number you want to record.
3) Press and hold down the "SET" button for 5 seconds. The display number will flash until the table has recorded the setting.
To position the table to your preset:
1) Enter your two-digit number on the keypad.
2) Press and hold the "GO" button until the table reaches the stored position. The table will stop moving if you stop pressing
the "GO" button.
NOTE: If the red light on the Comfort Control interface is illuminated, the table will not move because one of the safety switches has
been triggered. Read "Troubleshooting" (page 6) or "Some Safety Considerations" below for more information.
Some Safety Considerations
Carl’s Table has a collision avoidance system and will stop the table from moving if it encounters an obstacle while tilting or moving
downwards. Safety sensors are located under the CPU Holder, under the control box, and under the work surface. If a sensor is triggered,
the table will stop moving and the red light on the Comfort Control interface will illuminate.
To avoid injury, stay clear of moving parts while the table is in motion. Do not sit on top of the workstation.
Adjusting the Height and Depth of the Monitor Control System™
The Monitor Control System electronically adjusts the height and depth of the entire monitor bar. Use the buttons on the keypad to
adjust the settings. You can also adjust the tilt of each monitor manually.
Adjusting Your Lighting
Carl’s Table comes with four lights: two that provide the ambient light on the back panel and two task lights on flexible gooseneck arms
to illuminate the work surface. Task lighting is always controlled manually using the dimmer knob on the left side of the table. Ambient
lighting can be set to "Auto" or "Manual".
¡ Auto
When “Auto” is selected on the Mode toggle switch, CT08 adjusts the ambient lighting for you automatically. The table's Adaptive
Lighting System automatically maintains an appropriate contrast ratio between the image on the monitor and the surrounding light.
The sensor is on the end of a flexible gooseneck arm and can be adjusted as needed. Make sure the sensor is unobstructed so it can
take a proper reading.
¡ Manual
When “Manual” is selected on the Mode toggle switch, the dimmer knob for the Back Lights is active. Turn this knob to control the
brightness of back light manually.
Using Your Footrest
If you’re working standing up, you can swing out this footrest to alleviate pressure on your lower back. When you’re done, just swing it
back towards the table leg.