Renkus-Heinz IC2-FR - Manual (Page 88)

88
T e c h n i c a l S p e c i f i c a t i o n s
I C 2 1 2 S - F R S u b w o o f e r
Sensitivity:
Freq. Range:
Max SPL:
№. Transducers:
Dimensions:
Weight:
Power Required:
Hardware:
Enclosure:
Finish:
Power Connector:
Inputs:
On-Board Controls:
Computer Controls:
Status Indicators:
Digital Format:
PM-2LR AMPLIFIER:
Power Rating:
THD Distortion:
Hum & Noise:
1.4 V (for rated power output)
42 Hz to 120 Hz
136 dB peak
Two model SSL12-17, 12” woofers, 700 W pgm @ 8 Ohms (each)
18.5” H x 28.5” W x 23” D
(47 cm x 72.4 cm x 59 cm)
IC212S-FR: 160 Lbs (73 Kg)
IC212S-R-ICL: 160 Lbs (73 Kg)
90/136 V or 180/260 V AC, 50/60Hz.
13 A @ 120 V, 6.5 A at 240 V
16 Metric M10 attachment points, interlocking IC2 flying hardware
Finnish birch, perforated steel grille
Black or custom color paint
Weather resistant (black TuffTex)
Powercon locking connector
Analog audio & AES: looping XLR (female in,
male out) Phoenix 6-pin (looping 3-in, 3-out),
CobraNet:dual RJ45 connectors (for CAT 5 cable)
Mute button, Up & Down output level,
10 dB input pad (on Analog 1 input)
Push-To-Reset circuit breaker
Gain, mute, on/standby, input selection
compression, 9-band parametric EQ,
shelving & rolloff filters, delay
Power, signal, overdrive, thermal, mute,
input pad, failure
16, 20 or 24 bit PCM; 48 or 96 kHz
sample rate; selectable network latency
Class D amplifier/DSP processor
2 x 850 W RMS
< 0.05% typical
<100 dB (A weighted)
IC
2
Users Manual