Renkus-Heinz IC2-FR - Manual (Page 87)

Sensitivity:
Freq. Range:
Max SPL:
Horiz. Dispersion:
Vert. Opening Angles:
Aiming Angle:
Beam Control:
№. Transducers:
№. Amp. Channels:
Dimensions:
Weight:
Power Required:
Hanging Method:
Enclosure:
Inputs:
Controls:
Computer Controls:
Status Indicators:
Power Connector:
Finish:
Network Digital Format:
DSP/AMPLIFIER
Type:
Power Rating:
Freq. Range:
THD Distortion:
Hum & Noise:
1.0 V (for rated power output)
60 Hz to 20 kHz
131 dB peak @ 1 mater (+ 100 dB peak @ 30 meters )
120° (90° optional)
10° to 80° (computer adjustable)
adjustable from -30° to +30°
Effective down to 800 Hz (Lower when stacked))
Four 8” audiophile quality cone transducers,
Four 1” HF titanium nitride compression drivers
8
18.5” H x 28.5” W x 11.25” D (47 cm x 72.4 cm x 28.6 cm)
126 Lbs (58 Kg)
Universal 90/260 VAC, 50/60Hz. 80 VA Idle; 2000 VA @ rated power output
R-Hang Flying hardware, Metric #10 attachment points.
Finnish Birch with a perforated steel grille
Analog Audio & AES: Looping XLR (female in,male out) and Phoenix 6-pin (looping
3-in, 3-out)
CobraNet: Dual RJ45 connectors (for CAT 5 cable)
Mute button, Up & Down Output Level push buttons, 10 dB Input pad (on Analog 1
input), Push-To-Reset circuit breaker, Preset Selector
Gain, Mute, On/Standby, Input Selection, Compression, 9-Band Parametric EQ,
Shelving & Rolloff Filters, Delay
Power, Signal, Overdrive, Thermal, Mute, Input Pad, Failure, Digital Readout
Powercon locking connector
Black paint
16, 20 or 24 bit PCM; 48 or 96 kHz sample rate; selectable network latency
8-channel, Class D amplifier/DSP processor
250 Watts RMS per channel
+ 3, - 3 dB, 60 Hz to 20 kHz
< 0.05% typical
<100 dB (A weighted)
T e c h n i c a l S p e c i f i c a t i o n s
I C 2 A r r a y M o d u l e
87
Users Manual
IC
2