Nexo GEO D - Manual (Page 49)

GEO D RIGGING PROCEDURE Page 49/97
5.6 GEO SUB – GEO D Combined Cluster Flying Setup (2 motors required)
Flying a GEO SUB – GEO D combined cluster is very similar to what has been described in the
above section, except a long Extension Bar EX2 (instead of EX1) is required to extend top
compression point because of GEO SUB depth.
However, the section below details all steps to be completed for a safe setup.
Flying a combined GEO D10 / GEO SUB cluster requires:
• 2 x Motors properly rated
• 1 x GEO D Main Bumper (GEOD-BUMPER)
• 1 x GEO D long Extension Bar (GEOD-EXBAR2)
• 1 x GEOD Front Extension Bar if strong positive tilt is required (GEOD-EXBAR4)
• 1 x GEO D Bottom Bumper (GEOD-BTBUMPER)
• 1 x GEO D Chain Lever Hoist (LEVA0750 or LEVA1500)
• 1 x Chain Bag (CHBAG)
• 6 x GEOD push-pins per flown GEO SUB (BLGEOD)
• or 1 x GEOD shoulder bolts and nuts kit for fixed installations per flown GEO D (GEOD-BNFIX)
IMPORTANT
Each of front, rear motor and chain lever hoists must be rated to support the entire
cluster weight.
Please check configurations in Geosoft2 for proper motor and chain lever hoists rating
5.6.1 Bumper Assembly
• Strong bumper positive tilt only; connect the Front Extension Bar Bumper through the Link
Points the with the two axes using corresponding holes (see drawing below), and ensure that
these axes are properly locked with supplied “R” clips;
Link Points
LINKING GEOD BUMPER AND EXTENSION BAR EXBAR4
• Connect the Long Extension Bar to the Main Bumper through the Link Points the with the two
axes using corresponding holes (see drawing below), and ensure that these axes are properly
locked with supplied “R” clips;
LINK POINTS
LINK POINTS
LINKING GEOD BUMPER AND EXTENSION BAR EX2