Nexo GEO D - Manual (Page 34)

Page 34/97 GEO D RIGGING PROCEDURE
5.4.3 Bumper to first GEO D10 assembly
IMPORTANT
GEO D10 can be flown “Left” or “Right” :
- “Left” means Nexo logo on front grid is left as seen from front;
- “Right” means Nexo logo on front grid is right as seen from front.
GEO D10 can be connected to bumper “Left” or “Right” by simply flipping the cabinets
upside down: do not reverse rigging plates
Whenever possible, NEXO recommends symmetrical designs (preferably NEXO logo
inwards in stereo configurations)
‘’LEFT’’ CONFIGURATION ’’RIGHT’’ CONFIGURATION
4 push-pins (BLGEOD, 10mm diameter x 20 mm length) connect the top GEO D10 to the bumper.
• Position the bumper on the first GEO D10 by lifting or lowering bumper assembly with motor
hoist;
• Link the GEO D10 to the bumper assembly using the four 10mm x 20mm push-pins; front
bumper connects at GEO D10 front articulation point, rear bumper connects at “LIFT” GEO D10
rigging plates holes;
• Check that all push-pins are in their locked position.
• Ensure that no objects have been placed accidentally on the top of the bumper as they may fall
when the system is lifted.