Nexo GEO D - Manual (Page 33)

GEO D RIGGING PROCEDURE Page 33/97
• Connect the Short Extension Bar EX1 to the Main Bumper through the Link Points the with the
two axes using corresponding holes (see drawing below), and ensure that these axes are
properly locked with supplied “R” clips;
LINKING GEOD BUMPER AND EXTENSION BAR EXBAR1
• Connect the bridle ring to the motor hoist, the bridle adjustable leg to the front rigging point and
the bridle fixed length leg to the rear rigging point;
• Attach the chain hook of the LEVA750 or LEVA1500 Chain Lever Hoist to the motor (see drawing
below) after passing the chain through Short Extension Bar EX1 behind rear compression point;
• Install the compression wheel by removing the axis located at compression point, inserting the
wheel and setting back the axis in position; ensure that the axis is properly locked with supplied
“R” clip and that chain is properly located behind the axis;
• Lift the bumper assembly so that top GeoD can be connected at convenient height.
CONNECTING MOTOR, BRIDLE, WHEL AND CHAIN LEVEL HOIST