PreSonus SL Room Control - Manual (Page 20)

4 Speaker Groups
4.6 Speaker Edit Page
SL Room Control
User Guide
18
4.6 Speaker Edit Page
To edit the parameters of any loudspeaker on the network or in a group, click or tap
on the “gear” below the meter in its icon. This will access the Speaker Edit page for
that speaker from anywhere in SL Room Control.
Speaker Edit Enable. Enables/Disables speaker editing.
By default, Speaker Edit is enabled. Click or tap the button to disable
speaker editing; this will bypass all parameters, and you will no longer have
remote control over the speaker. In this way, you can monitor performance
without risking making any changes to a speaker or A/B your changes.
Mute. Mutes the loudspeaker.
Click or tap the Mute button to mute the currently selected loudspeaker.
You will be alerted when a loudspeaker is muted wherever
its icon is visible in SL Room Control.
Solo. Solos the loudspeaker.
Click or tap the Solo button to mute every other speaker in the group.
Temperature. Displays the current temperature of the amplifiers.
Temperature monitoring for your loudspeaker is available in real-
time from the Speaker Edit page. This is especially useful when
using your loudspeakers in elevated temperatures.
Note: Your loudspeaker should remain below 147˚ F (63.9° C). If it exceeds
this temperature, power off your loudspeaker immediately.
HPF (full-range only). Remotely enables/disables the highpass filter.
When enabled, this button engages a highpass filter that removes
frequency content below 100 Hz. (This low-frequency content may
introduce destructive cancellation and reinforcement when combined
with the highest frequencies reproduced by a subwoofer.) The filter may
also be used to remove stand thumps, mic-handling noise, etc.
Power User Tip: In addition to the highpass filter, phase- and time-alignment settings
are applied. These settings are optimized for use with the StudioLive 18sAI; however
you can use this mode with any subwoofer. Because these are fundamental tuning
parameters, your loudspeaker will mute momentarily while they are applied.