PreSonus SL Room Control - Manual (Page 10)

2 Networking Your Loudspeaker
2.3 Step 3: Connecting your Network
SL Room Control
User Guide
8
7. If any of the loudspeakers have the “No WiFi Installed” warning, you will be
prevented from joining a new network. Verify that your USB LAN adapter is
connected and power-cycle your loudspeaker. Note: StudioLive loudspeakers do not
support hot swapping. The USB LAN adapter must be connected when you power on
your loudspeaker.
8. From the network browser, select the wireless network to which
you’d like to connect your loudspeakers. Only networks that can
be joined by every speaker in the browser will be selectable.
9. Enter the password for your wireless network. Once the network
information has been stored in your loudspeakers, you can
disconnect the Ethernet cables from your router.
10. Click or tap the Rescan button to verify that your speakers have successfully
joined wirelessly to your network. If your speakers do not appear within
10-30 seconds, power cycle them, reboot SL Room Control and click or tap
the Rescan button again. If they are still not detected, repeat steps 1-9 and
verify that you are entering the correct password for your wireless network.
Power User Tip: Once your loudspeakers are wirelessly connected to one
network, you can connect them to another network wirelessly, as well, as long
as both networks are within range of the loudspeaker and your device.