Stuart Turner Pumps - Lifting Station - Manual (Page 11)

- 11 -
Cont ...
6 MAINTENANCE
6.11 The Lifting Station should only be used for the removal of grey water.
6.12 AVOID KITCHEN TOWELS, HAIR, FOOD WASTE, CIGARETTES
ETC, as this will damage the unit and will invalidate our guarantee.
6.13 Do not pour in any corrosive liquids such as acids, solvents, oil,
paint stripper, as this will damage the unit, and is NOT covered under
the guarantee.
6.14 Acid based descalents and aggressive cleaning agents must not come
into contact with the unit.
If in any doubt as to the suitability of the chemical solutions, please
contact our Pump Assist Helpline.
6.15 As water is heated scale deposits are released in areas of hard water.
Scale can cause the mechanical seal to stick if left alone for long
periods. We recommend the unit to be run for at least 3 minutes every
four weeks to “exercise” all working parts.
It is also recommended that a non acid based descalent is used to
remove limescale. To be carried out twice a year.
A non acid based cleaner can be used to clean all sanitary appliances
connected to the unit.
6.16 There should be no dripping from the bathroom sanitary ware or
kitchen appliances, as this will cause the unit to operate.
6.17 Do not use any connected bathroom sanitary ware or kitchen
appliance in the event of a power failure.
6.18 Care should be taken to protect the unit and pipes
from frost and freezing.
6.19 Should the unit start to release oder's the charcoal
filter should be changed ( Fig. 1).
6.20 No other maintenance is required under normal
working
conditions.
WARNING: The Lifting Station must be
disconnected from the power supply before
replacing the filter.
Contact Stuart Turner for spares replacement.
6.21 For Further Technical Support: Phone the Stuart Turner Pump Assist team on
0844 98 000 97. Our staff are trained to help and advise you over the phone or
arrange for a service engineer to call.
Fig. 1
Charcoal
filter