3 pump connections – Stuart Turner Showermate eco S2.0 bar Twin User Manual
Page 9

- 9 -
Cont ...
3 PUMP
CONNECTIONS
Do not use stainless steel, chrome or nickel plated pipe with the
flexible hose push-in plumbing connections.
Do not introduce solder flux into the joint or surrounding area as
connectors will be attacked and may fail.
All solder joints should be completed and flux residues removed
before final connection to push-in connections, on the flexible hose.
Do not allow contact with oil or cellulose based paints, paint
thinners or strippers, acid based descalents or aggressive cleaning
agents.
Never operate pump with inlet and/or outlet isolating valves in the
closed position. Damage will occur!
3.11
Hose to pump: The pump inlet and outlet ports have moulded fittings which
are specifically designed for connection to the G ¾ female running nuts on the
flexible hoses. The hose end running nut is fitted with a rubber sealing washer
which is held captive within the nut assembly. Locate the hose into position and
screw the nut fully onto the fitting by hand. Finally nip tight with pliers (4/5 Nm)
for a water tight seal
(do not overtighten).
Fig. 8
Flexible hose
G ¾ running nut
assembly
Port fitting
Rubber sealing
washer (captive
in nut assembly)