Yokogawa Removable Chassis DX1000N - Manual (Page 7)

7
IM 04L41B01-03E
Setup Items
• Bar graph > Base position
Set the base position of the bar graphs to
Normal, Center, Lower, or Upper. The bar
graphs for the different settings are shown below.
When the Display Direction of the Bar Graph Is Vertical
• Normal
Value at the bottom of the bar graph: Span lower limit or span upper limit (or scale
lower limit or scale upper limit), whichever is
less
Value at the top of the bar graph: Span lower limit or span upper limit (or scale
lower limit or scale upper limit), whichever is
greater
Starting point of the bar: Bottom edge
• Center
Value at the bottom of the bar graph: Same as with
Normal.
Value at the top of the bar graph: Same as with Normal.
Starting point of the bar: Center
• Lower
Value at the bottom of the bar graph: Span lower limit (or scale lower limit)
Value at the top of the bar graph:
Span upper limit (or scale upper limit)
Starting point of the bar: Bottom edge
• Upper
Value at the bottom of the bar graph: Same as with
Lower.
Value at the top of the bar graph: Same as with Lower.
Starting point of the bar: Top edge
Normal Center Lower Upper
V
S
V
L
V
S
V
L
V
lower
V
upper
V
lower
V
upper
Vupper: Span upper limit (or scale upper limit)
Vlower: Span lower limit (or scale lower limit)
VL: Vlower or Vupper, whichever is greater
VS: Vlower or Vupper, whichever is less
: Starting point of the bar
Normal Center Lower Upper
0.0
-100.0
0.0
-100.0
–100.0
0.0
–100.0
0.0
Example: When the span lower and upper limits of the input
range are 0.0 and –100.0, respectively
Operations on the DX1000/DX1000N/DX2000