Yokogawa ADMAG AXF - Manual (Page 111)

IM 01E20C01-01E
REVISION RECORD
Title: AXFA11G Magnetic Flowmeter Remote Converter
[Hardware Edition/Software Edition]
Manual No.: IM 01E20C01-01E
2.2 Added the fuse of “Power supply code 2 (24 V AC/DC)”.
4.1 Added the caution note of route the power and output signal cable.
4.4.4 Added the important note for a 24 V power supply version (power
supply code 2).
Added the item “(2) Required Power Supply Voltages”.
Added the important note on pulse rate range of active pulse output.
5.1 Added the important note on operation display unit and write protection
function.
5.2.1 Corrected the flow chart.
Corrected the data range from “0.00001” to “0.0001”.
(B23, C42, C49, F30 to F36)
Corrected the position of decimal point from “0 to 5” to “0 to 4”
(B23, B31, B33, C42, C46, C49, D11, E11, F30 to F36)”
Corrected the position of decimal point from “0 to 5” to “0 to 2”. (C32)
J10, J11, J12 Added the sentence about indications action of display unit.
J31
Added the parameter setting table for “Power supply code 2”.
7.2.1 Corrected the “Receiving instrument” of “Figure 7.2”
Added the important note on write protection function.
Added the important note on write protection function.
Corrected the “Protection”.
Corrected the “Safety Requirement Standards”.
Corrected the “EMC Conformity Standards”.
Added the item of “Power supply code 2” to “NORMAL OPERATING
CONDITION”.
Added the fuse of “Power supply code 2 (24 V AC/DC)” to
“ACCESSORIES”.
Added the code “-2 (24 V AC/DC)” to “MODEL AND SUFFIX CODE”.
Added the note for “Power supply code 2 (24 V AC/DC)” to optional
code A (Lightning protector).
(4) Changed the warning note of "Maintenance".
4.3 Added the important note for the wiring ports.
5.2 Changed the note of entry mode.
Added the NOTE for display unit setting.
Added the NOTE for display unit setting.
8.1.2
Deleted the section of "Communication Line Requirements".
10.1 Changed the warning note and important note of "Maintenance".
10.1.1 Changed the caution note of "Fuse Replacement".
Deleted the Figure 10.1.1.
10.1.2, Deleted the section "Display Unit Replacement" and section "Amplifier
10.1.3 Replacement".
10.2
Added the important note for "Setting of Switches".
10.2.1 Added the section "Lifting of display unit".
Deleted the "Communication Distance" and "Cable Length for Specific
Applications" from item of HART.
Edition Date Page Revised item
5th
6th
Oct. 2006
May 2007
2-1
4-1
4-5
4-8
5-1
5-3
6-3 to 6-7
6-30
6-32
7-3
8-1
11-1
11-4
11-5
11-6
1-2
4-2, 4-3
5-3
5-4, 5-6, 5-8,
5-9, 9-2, 9-4
8-2
10-1
10-1 to 10-2
10-2
11-1