Proface FP3900 - 19 Flat Panel" - Manual (Page 51)

FP-3710K Series User Manual
5-6
(3) Insert each of the fasteners as shown below. Be sure to pull the fastener back until it is flush with the
rear of the attachment hole.
(4) Tighten the fastener screws equally in a diagonal pattern by using a Phillips screw driver. When tighten-
ing them, slowly increase the torque. (12 places)
• Do not use too much force, since it may damage the FP unit. A torque of only 0.8
N•m, are sufficient to tighten these screws.
Installation panel
Hook