Proface FP3900 - 19 Flat Panel" - Manual (Page 102)

Chapter 10 Maintenance
10-9
(10) Lower the LCD holder, connect the backlight cables to the backlight connectors, and secure the cables
with the clamp. (Repeat the steps (7) through (10) for the other backlight unit.)
(11) Secure the backlight unit with the upper and lower backlight attachment screws. The torque should be
0.147 N • m.
(12) Confirm that the backlight unit is secured in place, and then secure the LCD holder with the eight
screws. The torque should be 0.5 N • m.
(13) Install the rear cover on the front module with the eleven (11) attachment screws.
(14) Perform steps (1) to (4) in reverse order.
• Be sure to insert the cable into the connector securely. Failure to do so may
damage the connector.
• To prevent the cable from being caught when reassembling the FP unit, be sure
to secure the backlight cables with the clamp before installing the rear cover.
• Pay attention not to catch the cable in the gap between the rear cover and the
front module.
• If any of the screws is missing, check if it fell inside the FP unit’s chassis. If the
power is turned ON while a screw is inside, it may cause an accident or fire.