SaltDogg 92426SSA Under Tailgate Spreader - Manual (Page 4)

4
TM
3
2
1
8
5
6
7
4
Hydraulic Installation Instructions
A. During assembly take precautions to keep all
hydraulic components as clean as possible.
B. Allow enough hose length to prevent kinking
and stretching of the hoses and to permit raising
the dump body. Support long hoses with wire ties
or clamps.
C. Protect hoses from wear caused by sliding and/
or vibration.
D. For proper rotation of auger and spinner motors,
hoses may be reversed.
Note: Use of a pipe joint sealant compatible with
hydraulic oil is recommended for all screw fittings.
E. Use swivel type hose ends to connect hoses to
flow valve. Damage to valve body may occur if the
fittings in flow valve are over tightened
F. To achieve an additional positive shutoff of the
auger motor, the inlet flow must pass through
the bulkhead fitting (preinstalled on the bottom
tray), through latch bracket, through the quick
disconnect fitting assembly (preinstalled on the
side plate) then to the motor.
G. Buyers Products recommends a minimum flow
rate of 9 GPM @ 1000 rpm to operate our spreaders.
Valve 1/2" Quick Disconnects
Side Plate Mounted
1/2" Quick Disconnects
3/4" (1)
Wire Hose
3/4" (1) Wire Hose
1/2" (1) Wire Hose
1/2" (1) Wire Hose
1/2" (1) Wire Hose
Auger Motor
CW Rotation
Spinner Motor
CCW Rotation
3/4" Quick
Disconnects
3/4" (2) Wire Hose
1-1/4" Spiral
SuctionHose
3/4" (2) Wire Hose
1/2" (1) Wire Hose
Tank
Pump
3
1 T
A
P
S
Recommended Parts (not included)
Hydraulic Flow Diagram
Parallel Linkage, Spinner Frame & Bar Installation Drawings (cont.)
Bill of Materials
ITEM QTY. DESCRIPTION CARBON STAINLESS
1 1 Spinner Frame Assy. 3020184 3018416
2 1 Spinner Shield 924F0015 3006659
3 1 Spinner Disk Assy. 3001472A 3001472A
4 2 Linkage Rods, Welded 924F0012 924F0012
ITEM QTY. DESCRIPTION CARBON STAINLESS
5 1 Hinge Rod 924F0018 3006646
6 1 Spinner Lug 924F0013 3006645
7 1 Bar 924F0014 924F0014
8 1 Height Adjustment Bracket 3020185 3017175
ITEM PART NO. QTY DESCRIPTION
1 HV715 1 Dual Flow Regulator Valve
2 HVC1 1 Dual Flow Regulator Console
3 SMR15 1 15 Gallon Reservoir