SaltDogg SHPE3000 Series Electric Drive Poly Hopper Spreader - Manual (Page 3)

3
TM
SPACER
26.0
12.0
20.0
TRUCK WIDTH
Fig. 4
Insert Hooks Into Slots.
Secure Chute with Latches
CAUTION!
Inspect straps and hardware after each time spreader is loaded.
Tighten straps and hardware if necessary.
WARNING!
Important! Do not use ratchet straps or tailgate latch exclusively!
Always fasten spreader to the vehicle!
Fig. 3
I. Measure the distance from the front of the truck bed to
the front of the hoppers front legs. Fabricate spacer to fit
between front of the spreader and front of the bed using
2 x 8 boards and install it between the spreader and truck
bed front wall as shown in Fig. 4.
J. In addition, secure spreader using four ratchet straps.
Attach straps to tie-downs. Tighten straps evenly.