Ramsey Winch RPH-35000 W/ 2 SPEED MOTOR User Manual

Page 9

5. Pull drum assembly (item #1) upward from end bearing (item #10). Remove quad-rings (item #40 & #41)

from grooves in drum bushings. Remove input shaft (item #12), clutch spring (item #44) and washer (item
#25) from end bearing (item #10). Examine key (item #11) and input shaft for signs of wear, replace if dam-
aged.
Examine drum assembly (item #1) for signs of wear. If splines inside of drum driver (332162) are damaged,
drum driver must be replaced. Remove drum driver by unscrewing (8) capscrews (414964). Place well oiled o-
ring (462053) into drum driver groove and attach driver to drum (332196) using (8) capscrews (414964).
Torque capscrews to 120 ft. lbs. each, in criss-cross pattern.
Press old bushings from drum and drum driver. Remove o-rings (462054 & 462052) from grooves in drum and
drum driver bushing (412088). Place well oiled o-rings (462054 & 462052) into grooves in drum and outer
diameter of drum driver bushing (412088). Press new bushing (412087) into end of drum opposite drum driver
and press bushing (412088) into drum driver until flange of bushings are flush against drum and driver.