Ramsey Winch RPH-35000 W/ 2 SPEED MOTOR - Manual (Page 7)

INSTRUCTIONS FOR OVERHAUL
1. Drain oil from gear housing (item #10) by removing plug (item #42) from end bearing. Remove reducer and
relief fitting (items #41 & #36).
If new air cylinder is required,
remove air cylinder (item #32)
from adapter (item #4) by
removing (4) capscrews (item
#23). Remove washer (item
#26), nut and setscrew (items
#27 & #22) and insert (item
#29) from end of air cylinder
rod. Apply Loc-tite to threads of
nut (item #27) and thread onto
setscrew (item #22) to 3/8 inch
from drive end, as shown below.
Apply Loc-tite to threads of
setscrew and thread insert (item
#29) over end of setscrew and
against nut. Use setscrew and
nut to thread insert (item #29)
into end of air cylinder rod.
Tighten nut against cylinder rod, keeping 3/8 inch distance from drive end of setscrew to nut. If breather vent
(item #37) is damaged, remove and replace. Remove air cylinder adapter (item #4) and gasket (item #36)
from gear housing cover by unscrewing (4) capscrews (item #18).
2. Disconnect tube (item #45) from elbow
(item #31) on top of valve (item #46)
and elbow on brake assembly. Remove
motor (item #39) and gasket (item
#35) by removing (2) capscrews (item
#21). Remove valve (item #46), if
needed, from motor by loosening (4)
capscrews.
5