Ramsey Winch RPH-35000 W/ 2 SPEED MOTOR - Manual (Page 12)

10. Apply RTV sealing compound to ring gear mounting surface of end bearing (item #10). Place ring gear onto end
bearing, aligning holes in ring gear with holes and gear housing end bearing. Use (2) capscrews to temporarily
secure ring gear to end bearing.
Place (2) gear carrier assemblies into ring gear
meshing carrier gears with ring gear. Remove (2)
temporary capscrews, making sure that ring gear
and carrier assemblies are securely against end
bearing (item #10). Apply RTV sealing compound
to cover mounting surface of ring gear (item #3)
and attach cover to ring gear. Use (12) capscrews
(item #16) to secure gear box to gear housing end
bearing. Torque capscrews to 39 ft. lbs. each, in
criss-cross pattern.
11. Slide input sun gear over shifter shaft (item #13) and mesh with teeth of input carrier. Apply grease to input
thrust washer and place into slots of air cylinder adapter (item #4). Place gasket (item #34) into position on
gear box cover with sealer and attach adapter to cover using (4) capscrews (item #18). Apply Loctite PST
thread sealer to threads of capscrews. Torque capscrews to 13 ft. lbs. each, in criss-cross pattern.
Pull rod from air cylinder as far as possible.
Slide washer (item #26) over setscrew (item
#22) and against nut attached to air cylinder
rod. Place setscrew into hole of shifter shaft
(item #13). Attach new air cylinder (item
#32) and gasket (item #34) with sealer, to
adapter using (4) capscrews (item #23).
Apply Loctite PST thread sealer to threads of
capscrews. Torque capscrews to 5 ft. lbs.
each, in criss-cross pattern.
10