Ramsey Winch RPH-35000 W/ 2 SPEED MOTOR - Manual (Page 10)

6. Remove output coupling (item #8) and coupling shaft (item #6) from end bearing (item #10). Examine bear-
ings (item #14), pressed in output coupling (item #8), for signs of wear. Replace bearings, if necessary, by
pressing old bearings from coupling and press new bearings (item #14) into each end of output coupling (item
#8). Place coupling shaft (item #6) into bearings (item #14).
7. Remove (12) capscrews (item #16) to pull gear housing cover from ring gear. Remove input thrust washer,
sun gear and carrier assemblies from inside of ring gear. Remove ring gear from end bearing (item #10).
Examine shifter shaft (item #13) for signs of wear, replace if necessary. Examine bushing (item #15) for signs
of wear. Replace bushing, if necessary, by pressing old bushing from housing and pressing new bushing into
place.
8