Ramsey Winch RPH-35000 W/ 2 SPEED MOTOR User Manual

Page 13

12. Align keyway of coupling (item #7) with key and end of input shaft sticking out of the end bearing. Slide cou-

pling over end of shaft. Place gasket (item #33e) into position on motor mounting surface of end bearing (item
#9). Insert brake shaft with key (item #33c) into coupling. Use (2) screws (item #20) to attach brake adapter
plate (item #33d) to motor end bearing. Alternately tighten one, then the other of the capscrews (item #20) in a
back and forth manner, thus compressing spring (item #44) and pulling the adapter plate down against end
bearing (item #9). Torque capscrews to 85 ft lbs each. Re-attach brake (item #33a) to adapter plate using
brake assembly screws (item #47). Torque capscrews to 97 ft. lbs. each.

NOTE: Care must be taken to assure brake and adapter plate are seated properly prior to installing 1/2-13UNC

assembly bolts. Damage will occur to rotor stack or shaft snap ring if not properly seated.

13. Attach motor (item #38) with gasket

(item #35) to brake (item #33). Use
(4) capscrews (item #21) and torque to
74 ft. lbs. each. Securely connect tube
(item #45) to fitting (item #31) on top
of valve and fitting (item #30) on top of
brake (item #33).

33e

33d

33e

33a

33c