Ramsey Winch RPH-25000 (JERR-DAN) - Manual (Page 14)

13. With pin (item #69) installed in coupling, slide coupling (item #11) over end of input shaft
below. Slide coupling over end of shaft (item #16). Place gasket (Item #58) into posi-
tion on motor mounting surface of end bearing (item #13). Insert brake shaft into cou-
pling. Use (2) screws (item #33) to attach brake assembly to motor end bearing. Torque
capscrews to 85 ft lbs each.
14. Attach motor (item #61) with well oiled o-ring (item #64) to brake (item #55). Use (2)
capscrews (item #32) and torque to 74 ft. lbs. each. Securely connect tube (item #71)
to elbow (item #48), in valve (item #72), and brake (item #55).
12