Ramsey Winch RPH-25000 (JERR-DAN) - Manual (Page 11)

7. Remove output coupling (item #12) and coupling shaft (item #10) from end bearing (item
#14). Examine bearings (item #21), pressed in output coupling (item #12), for signs of
wear. Replace bearings, if necessary, by pressing old bearings from coupling and press
new bearings (item #21) into each end of output coupling (item #12). Place coupling
shaft (item #10) into bearings (item #21).
8. Remove (8) capscrews (item #25) to pull gear-housing cover from ring gear. Remove
input thrust washer, sun gear and carrier assemblies and spacer (item #18) from inside
of ring gear. Examine splines of ring gear and if necessary, remove ring gear from end
bearing (item #14) by removing (12) capscrews (item #35). Examine bushing (item
#23) for signs of wear. Replace bushing, if necessary, by pressing old bushing from
housing and pressing new bushing into place.
Apply RTV sealing compound to ring gear-mounting surface of end bearing (item #14).
Place ring gear onto end bearing, aligning holes in ring gear with holes and gear housing
end bearing. Secure ring gear to end bearing using (12) capscrews (item #35). Torque
to 44 ft.lbs, each in a criss-cross pattern. Examine shifter shaft (item #17) for signs of
wear, replace if necessary.
9