Ramsey Winch HD-P8000 W/FRAME (JERR-DAN) - Manual (Page 12)

Remove tie plates (items #37) from feet of end bearings by unscrewing cap-
screws (items #15). Slide motor end bearing (item #9) and drum (item #1)
from gear housing end bearing.
Remove input shaft (item #11) from end bearing. Inspect shaft and output sun
gear (item #8) for damage and replace if necessary. To remove the output sun
gear, remove the snap rings (items #39) and thrust washer (item #45) and pull
off the end of the shaft.
Remove bushing (item #13) and o-ring (item #34) from motor end bearing.
Place new, well-oiled o-ring into groove inside of end bearing and press new
bushing onto end bearing.
15
37
1
11
8
45
39
9
34
13
12