Ramsey Winch HD-P8000 W/FRAME (JERR-DAN) - Manual (Page 15)

Set winch with gear housing end down on work surface.
Install well-oiled o-rings and backup rings into grooves on outside of brake pis-
ton and backup brake piston as shown in cross-section A-A below.
Piston, backup piston, brake discs and stators must be clean and free of grease
and oil.
Insert brake discs (item #5) and stators (item #4) into gear end alternating,
with stators first and last.
Insert backup brake piston (item #7) into motor end and insert brake piston
(item #6) into it. Apply even pressure on piston when installing.
Install retaining rings (item #40) into grooves in motor end housing.
SECTION A-A
A
A
DRUM SIDE
MOTOR SIDE
33
28
32 30 29 31
7 6
5
4
32
30
7
28
33
29
31
6
40
15