Ramsey Winch HDG-350 (JERR-DAN) {CURRENT} User Manual

Page 17

15.Place thrust washer (item #62) over end of

drum shaft and slide downward until spacer
rests on drum. Press drum downward to
compress springs in gear housing.

Insert keys (item #43) into keyways with
sharp edge of keys pointing outward and
notched end of keys upward. A rubber or
brass mallet will be needed to gently tap
keys into position.

Apply Mobilith SHC 007 Synthetic grease to
keys and end of shaft. place jaw clutch
(item #6) over end of shaft and slide jaw
clutch over keys.

Set clutch housing (item #14) over end of
drum shaft. Pull jaw clutch (item #6)
upward, toward clutch housing, enough to
allow yoke, in clutch housing, to fit properly in
groove around jaw clutch.

16.Attach frame assembly

(item #1) using six cap-
screws (item #30) with
lockwashers and two
capscrews (item #29)
with lockwasher. Torque
capscrews to 34 ft. lbs.
(46 Nm.) each. Insert
plug (item #48) into bot-
tom of gear housing.
Permatex may be applied
to threads to help prevent
leakage.

Attach adapter rod (item
#38) to clutch shaft using pin (item #49).

Pour 1 pint of SAE 140 EP gear oil into hous-
ing through hole in top of housing. Pipe plug
(Item #47) should then be placed into hole on
top of gear housing. Tighten securely.

30 37