Ramsey Winch HDG-350 (JERR-DAN) {CURRENT} User Manual

Page 14

6. Check for signs of wear on gear teeth.

If replacement of gear is necessary,
replace as follows:

a) Press gear (item #11) from shaft

(item #18).

b) Examine shaft keys and keyways. If

distortion of keys and/or keyways is
evident, shaft and keys should be
replaced.

c) Use a soft hammer to gently tap keys

(item #44) into keyways. Press gear (item
#11) over shaft and keys. Gear must be
centered over keys.

7. Remove seal (item #55) from back of

(item #13) gear housing. Press bushing
(item #23) from gear housing. Press
new bushing and seal back into place.

8. Check drum bushings (item #22) for

signs of wear. Replace if necessary by
pressing old bushings from drum.
Press new ones into place.

9. Examine shifter assembly (item #2)

for damage to yoke. Yoke should be
firmly attached to shaft, yet, able to
swivel freely around shaft. Replace if
necessary.

Install new shifter assembly (item #2)
by placing end of shaft, opposite yoke,
through spring (item #60) and into
housing (item #14).