Ramsey Winch HDG-350 (JERR-DAN) {CURRENT} - Manual (Page 16)

13.Press bearing (item #21) onto worm and into
housing. NOTE: Be sure that thick shoulder of
bearings outer race (side with manufacturer's
name and part number) is out, away from worm
threads. Place gasket (item #40)
onto adapter (item #3). Attach
adapter to gear housing using four
(4) capscrews (item #32). TIGHTEN
CAPSCREWS TO 12 FT. LBS. (16.3
Nm.) EACH. Insert key (item #16)
into keyway of worm shaft. Slide
tapered end of coupling (item #7)
over end of worm shaft. Be sure roll
pin (item #50) is in coupling.
Place motor shaft, with key in key-
way, into coupling. Secure motor to
adapter, using two (2) capscrews
(item #33) and lockwashers. TIGHT-
EN CAPSCREWS TO 75 FT. LBS. (102 Nm.)
EACH.
14.Place winch with gear housing
cover down on work bench.
Drum shaft should be in vertical
position. Slide thrust washer
(item #62) over drum shaft
and slide downward until wash-
er rests on gear housing. Set
springs (item #58) into pockets
of gear housing with drag
brakes (item #39) on top of
springs. Slide drum assembly
(item #10) onto drum shaft
with drum jaws upward.
3
33
MOTOR
32
50
54
21
7
40
16
16
39
58
62
10
16