Ramsey Winch HDG-350 (JERR-DAN) {CURRENT} User Manual

Page 13

3. Remove motor and coupling (item

#7) from (item #3) adapter by
unscrewing two (item #33) cap-
screws with lockwasher.

Remove key (item #16) from worm
shaft. Unscrew four capscrews (item
#32) and remove adapter from gear
housing. Replace adapter seal (item
#54) and gasket (item #40).

4. See page 8 for servicing the oil

cooled brake. Remove brake
housing from gear housing by
unscrewing four capscrews
(item #31). Remove worm
(item #19) and bearings (item
#21) from gear housing. Use
soft hammer to gently tap input
end of worm and drive worm
and bearing from gear housing.
Once worm has been removed from housing, bearing
can be pressed from end of worm.

Check for signs of wear or damage to worm (item
#19) and bearing (item #21). Replace if necessary.

5. Remove gear housing cover (item #9)

from gear housing (item #13) by
unscrewing capscrews (item #26).
Thread two of the capscrews into the
two tapped holes of cover and tighten.
This will pull the cover loose from gear
housing.

Remove cover gasket (item #42) and
pull shaft (item #18), with gear
attached, and thrust washer (item #62) from gear
housing.

MOTOR